Sutter Instrument Lambda 10-3, Operation Manual

Page: 100 / 132

LAMBDA 10-3 OPERATION MANUAL – REV. 3.03 (20110829)
88
After the Lambda 10-3 has been placed in the local off-line mode, the TTL IN settings menu
is reached by first pressing the MODE key, which displays the Mode Menu as shown next.
In the Mode Menu, press 3 to go to the TTL Enable/Disable Menu.
If pressing 1 to enable TTL for Shutter A or 3 for Shutter B, the TTL mode for the shutter
selected will be displayed (the content of each shutter’s TTL Mode Menu will always appear
the same).
Press 1 to configure TTL control of the shutter to open the shutter when a high signal is
applied to the shutter’s TTL input port. To have the shutter open when the TTL input goes
low, press 2
For toggle control of the shutter during the rising edge of a high signal on the TTL port,
press 3. Toggle means the shutter opens if it is closed, and closes if it is open.
If more TTL In changes are desired, press 1 in response to the screen shown next, or press 0
if not.
Once done with making TTL IN changes (pressing 0 when previous screen is displayed), the
display returns to the main status screen. For each shutter that has been enabled for TTL
IN, a “*” (asterisk) is displayed next to it. For example, the following screen shows that
Shutter A has its TTL IN enabled, whereas Shutter B does not.
WHEEL: A-25MM 0 1 B-NC C-NC L
SHUTR: A- OFF B-FAST OFF
1-ACTIVE WHEEL 2-SPEED 3-TTL 4-TEST
5-SHUTTER MODE 6-CONFIG 7-DEFAULT
SHUTTER A: 1-ENABLE TTL 2-DISABLE TTL
SHUTTER B: 3-ENABLE TTL 4-DISABLE TTL
SHUTTER OPEN ON: 1-HIGH 2-LOW
SHUTTER TOGGLE ON: 3-RISING EDGE
DO YOU WANT TO SET OTHER TTL OPTIONS?
1-YES 0-NO
WHEEL: A-25MM 0 1 B-NC C-NC L
SHUTR: A- * OFF B-FAST OFF