Sutter Instrument Lambda 10-3, Operation Manual

Page: 69 / 132

LAMBDA 10-3 OPERATION MANUAL – REV. 3.03 (20110829)
57
Table 5-8. “Get Controller Type and Configuration” command return codes and data.
Description
Possible Values
Total Total Total Total
Num. Num. Num. Num.
Bytes Bytes Bytes Bytes
Category Num
.
Byte
s
ASCII
String
Meaning
Controller Type 4 10-3 Lambda 10-3
WA-25 25mm
WA-32 32mm
WA-HS High Speed
WA-BD Belt Driver
WA-NC Not Connected
Filter Wheel A Type 5
WA-ER Error
WB-25 25mm
WB-32 32mm
WB-HS High Speed
WB-BD Belt Driver
WB-NC Not Connected
Filter Wheel B Type 5
WB-ER Error
WB-25 25mm
WB-32 32mm
WB-HS High Speed
WB-BD Belt Driver
WB-NC Not Connected
Filter Wheel C Type 5
WB-ER Error
SA-IQ SmartShutter
Shutter A Type 5
SA-VS Vincent Shutter
SB-IQ SmartShutter
29
Shutter B Type 5
SA-VS Vincent Shutter
5.5 5.5 5.5 5.5 Shutter Control without Remote Commands via Dedicated TTL Line Shutter Control without Remote Commands via Dedicated TTL Line Shutter Control without Remote Commands via Dedicated TTL Line Shutter Control without Remote Commands via Dedicated TTL Line
The Special Commands shown above can be sent to the controller via the serial RS-232 port
or the USB (Universal Serial Bus) port. The protocol used to transmit these commands is as
described above in this chapter. The features of the SmartShutter can be used even without
proper software support of the various modes of operation. The fast, soft and neutral density
modes can be selected from the keypad. When so selected, open and close commands and the
TTL input will act in the selected fashion.
For a description of this alternative method of remote shutter control, please refer to the
REMOTE CONTROL: LOGIC LEVEL INPUT chapter later in this manual.