Sutter Instrument Lambda 10-3, Operation Manual

Page: 48 / 132

LAMBDA 10-3 OPERATION MANUAL – REV. 3.03 (20110829)
36
4.2 4.2 4.2 4.2 Setting the Position of the Active Filter Wheel Setting the Position of the Active Filter Wheel Setting the Position of the Active Filter Wheel Setting the Position of the Active Filter Wheel
Pressing the corresponding numeric key when the controller is in the local mode chooses a
filter position on the wheel. Keys are read while depressed but the appropriate action will
occur only when the key is released. If a key is pressed while a move is in progress but
released after the move is over, the key will read normally. Keys pressed and released while a
move is in progress are ignored. The filter position currently located in the optical port will
be indicated on the display (see example above).
4.3 4.3 4.3 4.3 Toggling Shutter States (S1 and S2) Toggling Shutter States (S1 and S2) Toggling Shutter States (S1 and S2) Toggling Shutter States (S1 and S2)
Press the S1
S1 S1
S1 key on the 10-3 controller keypad to manually toggle the open/closed state of
Shutter A. S2 S2 S2 S2 performs the same operation on Shutter B.
4.4 4.4 4.4 4.4 Disp Disp Disp Displaying the Main Menu laying the Main Menu laying the Main Menu laying the Main Menu
In order to access the main menu in the local mode, press MODE. There will be a brief
display of the message:
The menu screen, shown below, then quickly replaces the momentary screen shown
previously:
4.5 4.5 4.5 4.5 Selecting Various Modes and Configurations with the MODE Key Selecting Various Modes and Configurations with the MODE Key Selecting Various Modes and Configurations with the MODE Key Selecting Various Modes and Configurations with the MODE Key
Pressing the MODE key while the Status screen is displayed, causes the following screen to
be displayed.
The menu shown provides for making the following settings:
1. Set active filter wheel for manual filter position control
2. Set the speed for the active filter wheel
3. Establish shutter TTL control
4. Enter test/demo mode
5. Select shutter mode (SmartShutter only)
PRESS KEY 0 TO EXIT THE MENU ANYTIME!!!
1-WHEEL 2-SPEED 3-SHUTTER TTL 4-TEST
SMART SHUTTER ONLY: 5-MODE 6-CONFIG
(Mode menu prior to Lambda 10-3 Firmware Rev. 1.21.)
1-ACTIVE WHEEL 2-SPEED 3-TTL 4-TEST
5-SHUTTER MODE 6-CONFIG 7-DEFAULT
(Mode menu in Lambda 10-3 Firmware Rev. 1.21 and higher.)