Sutter Instrument Lambda 10-3, Operation Manual

Page: 50 / 132

LAMBDA 10-3 OPERATION MANUAL – REV. 3.03 (20110829)
38
Table 4-1. Filter switching times (in milliseconds).
Number of Filter Positions Moved Number of Filter Positions Moved Number of Filter Positions Moved Number of Filter Positions Moved
Speed Setting Speed Setting Speed Setting Speed Setting 1 1 1 1 2 2 2 2 3 3 3 3 4 4 4 4 5 5 5 5
0* 0* 0* 0* 31 51 74 95 115
1 1 1 1 40 65 95 120 148
2
2 2
2 44 75 105 136 168
3
3 3
3 50 88 127 165 205
4 4 4 4 60 108 156 205 250
5 5 5 5 68 123 178 235 290
6 6 6 6 124 235 350 460 580
7
7 7
7 230 440 650 860 1100
* NOTE: NOTE: NOTE: NOTE: Speed 0 should be used only with 4-position filter wheels
(LB10-WHS4, LB10-WHS4IQ, or LB10-WHS4E).
4.8 4.8 4.8 4.8 Selecting Shutter TTL Control (MODE 3) Selecting Shutter TTL Control (MODE 3) Selecting Shutter TTL Control (MODE 3) Selecting Shutter TTL Control (MODE 3)
The way in which shutters can be controlled via the TTL input port is determined by
pressing MODE and then 3, whereupon the following menu is displayed.
4.8.1 4.8.1 4.8.1 4.8.1 Enabling Shutter TTL Control (MODE 3 1 or MODE 3 3) Enabling Shutter TTL Control (MODE 3 1 or MODE 3 3) Enabling Shutter TTL Control (MODE 3 1 or MODE 3 3) Enabling Shutter TTL Control (MODE 3 1 or MODE 3 3)
The TTL input port for Shutter A is enabled by pressing 1 and is disabled by pressing 2. The
TTL input port for Shutter B is enabled by pressing 3 and is disabled by pressing 4.
4.8.2 4.8.2 4.8.2 4.8.2 Determining the Shutter TTL Control Mode (MODE 3 1 1|2|3 or MODE 3 3 1|2|3) Determining the Shutter TTL Control Mode (MODE 3 1 1|2|3 or MODE 3 3 1|2|3) Determining the Shutter TTL Control Mode (MODE 3 1 1|2|3 or MODE 3 3 1|2|3) Determining the Shutter TTL Control Mode (MODE 3 1 1|2|3 or MODE 3 3 1|2|3)
Once TTL control for a shutter is enabled, the following menu is displayed which lists the
choices for the mode in which the TTL input for the shutter is to operate.
Press 1 to configure TTL control of the shutter to open the shutter when a high signal is
applied to the shutter’s TTL input port. To have the shutter open when the TTL input goes
low, press 2
For toggle control of the shutter during the rising edge of a high signal on the TTL port,
press 3. Toggle means the shutter opens if it is closed, and closes if it is open.
SHUTTER A: 1-ENABLE TTL 2-DISABLE TTL
SHUTTER B: 3-ENABLE TTL 4-DISABLE TTL
SHUTTER OPEN ON: 1-HIGH 2-LOW
SHUTTER TOGGLE ON: 3-RISING EDGE