Supero SUPERSERVER 6016T-NTF, User Manual

Page: 78 / 120

6-2
S
UPER
S
ERVER 6016T-URF/6016T-UF/6016T-NTRF/6016T-NTF User's Manual
Figure 6-1. Chassis: Front and Rear Views
System Reset
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the air
fl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
Control Panel System LEDs
Main Power Hard Drive Bays
Power Supply Modules PCI Expansion Slots (w/ riser cards)
Mouse/Keyboard
USB Ports
COM1 Port VGA Port Ethernet Ports
Slim DVD-ROM Drive
Note:
the SC815TQ-560UBP chassis (6016T-UF/6016T-NTF) has only a single power supply
module.