Supero SUPERSERVER 6016T-NTF, User Manual

Page: 56 / 120

5-8
S
UPER
S
ERVER 6016T-URF/6016T-UF/6016T-NTRF/6016T-NTF User's Manual
5-5 Installing Memory
Note: Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage.
Installing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with slot
P1-DIMM1A. For best performance, install memory modules of the same type
and same speed in the slots as indicated in the tables below.
2. Insert each DIMM vertically into its slot. Pay attention to the notch along the
bottom of the module to prevent inserting the DIMM incorrectly (see Fig. 5-5).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules
Memory Support
The X8DTU-F supports up to 96 GB of registered ECC DDR3-1333/1066/800 or
up to 24 GB of unbuffered ECC DDR3-1333/1066/800MHz SDRAM SDRAM in 12
slots. (RDIMM modules are supported.)
Notes
: Memory speed support depends on the type of CPU used. Due to OS limita-
tions, some operating systems may not show more than 4 GB of memory. Due to
Memory Population for Optimal Performance With One CPU (CPU1) Installed
Branch 0 Branch 1 Branch 2
3 DIMMs P1 DIMM1A P1 DIMM2A P1 DIMM3A
6 DIMMs P1 DIMM1A P1 DIMM1B P1 DIMM2A P1 DIMM2B P1 DIMM3A P1 DIMM3B
Memory Population for Optimal Performance With One CPU (CPU2) Installed
Branch 0 Branch 1 Branch 2
3 DIMMs P2 DIMM1A P2 DIMM2A P2 DIMM3A
6 DIMMs P2 DIMM1A P2 DIMM1B P2 DIMM2A P2 DIMM2B P2 DIMM3A P2 DIMM3B
Memory Population for Optimal Performance With Two CPUs Installed
CPU1 CPU2
Branch 0 Branch 1 Branch 3 Branch 0 Branch 1 Branch 3
6 DIMMs 1A 2A 3A 1A 2A 3A
12
DIMMs 1A 1B 2A 2B 3A 3B 1A 1B 2A 2B 3A 3B