86
FRAME LIMIT: (Frame Limit Setting) This is setting that determines whether or not to use visual frame
set limit. Refer to machine setting for visual frame limit setting on page. The default setting is NO.
JUMP LENGTH: (whether thread trimming should be determined by jump length). If a jump length is over
the set value, this function performs automatic thread trimming.
APPLIQUE: If the identical number needle bar is set consecutively when the appliqué setting is YES, the
machine stops automatically so the fabric can be trimmed without trimming the thread.
MACHINE FUNCTION
FLAT, CAP: Tells the machine if it is going to be stitching caps or flat goods. The default is FLAT (0). To
set up for CAP, enter(1).
CORDING: Enables the cording function. The default is NO (0). Input (1) to for YES.
BORING NEEDLE: Enables the boring needle. Select the number of the needle bar that will be doing the
boring work. The default is (0), and the default needle bar is the first needle bar. The trimming device and
the thread detecting function of the first needle is turned OFF when boring is enabled.
SEQUIN: Enables the sequin function. The default is NO. To setup for YES, enter (1).
UP_THD SENSE: (Upper thread detection) Determines whether or not the upper thread break detecting
sensor is enabled and, if so, the number of stitches to be detected. The upper thread will not be detected
when (0) is input. The default is(1), and up to 10 stitches can be selected for detection.
1] FLAT, CAP:FLAT
2] CORDING:NO
3] BORING NEEDLE:0
4] SEQUIN:NO