SunDash Radius 252, Operation & Assembly Instructions

Page: 7 / 40

6
Step 1
Remove floor assembly from carton marked “ To p”
The floor of your tanning unit consists of - two (2) parts
A- Base -lower floor
B. Floor -upper floor
Step 2
Position base in desired location. Align floor allowing
a minimum of 63" from back of base to insure
adequate distance to open door of unit properly.
Also, allow a minimum of 18" around the
parameter of the floor for ballast installation and
access from the rear of the unit.
(See Illustration 1)
NOTE: Check to insure all panel attachment
latches are fully open.
(See Illustration 2)
Step 3
Remove panel B front box marked “PLB” and locate
on base. Align slots in bottom plate of panel B with
alignment pins in floor. Attach panel B to base with
the two (2) attachment latches by placing the latch
into slot in booth panel. Press downward on latch
paddle, latch should snap into place securing panel
B to base.
(See Illustration 3)
Step 4
Remove panel A from box marked “PLA” and
locate on base. Align slots in bottom plate of
panel A with the alignment pins in floor. Align
left side of panel A with right side of panel B,
the side rails of both panels should nest together.
Attached panel A to base with the two (2)
attachment latches by placing the latch into
slot in booth panel. Press downward on latch
paddle, latch should snap into place securing
bottom of panel A to base. Attach panel A to
panel B with the upper panel latch located on
the top of panel B by repeating the above l
atching procedure.
(See Illustration 4)
Illustration 4
Illustration 3
Illustration 1
Illustration 2
Assembly Instructions