10
Intellitan Plus
Operating Instructions
To Set Time
STEP 1:
Press
s
on the button labeled time to reach desired setting in minutes.
STEP 2:
Press
“Start/Stop”
to begin operation. The session is counted down in minutes and seconds.
NOTE: If a session delay is preprogrammed (P04), the display will begin to flash the session
time. The display will continue to flash the session time for the duration of the session delay
according to the programming or until the
“Start/Stop”
button is pressed. If the
“Start/
Stop”
button is pressed before the session delay expires, the display will stop flashing and
the session time will begin to count down. At one (1) minute, before the start of the tanning
session, an audible beep will sound (if programmed in P02).
At thirty (30) seconds, before the
start of the tanning session, another audible beep will sound. At ten (10) seconds the audible
beep will sound and continue once
each second
until tanning unit lights. Once the tanning
unit has started, the session delay will not repeat on subsequent restarts.
To Stop Unit
STEP 1:
Press
“Start/Stop”
anytime during a session. This will stop the countdown and hold time. To restart
the unit simply press
“Start/Stop”
.
To Clear Time
STEP 1:
Press
“Reset”
the timer clears to read 00:00
NOTE:
If the unit is counting down, the
“Start/Stop”
button must be pressed before resetting.
Summary of Contents for Radius 252
