SunDash Radius 252, Operation & Assembly Instructions

Page: 13 / 40

12
P02
Parameter 2 is the chime mechanism that provides an audible ‘beep’ sound when the keys are depressed
and to indicate the various operations occurring. The audible beep can be turned on or turned of
f. The u nit
comes with the chime mechanism turned on to provide an audible beep. When parameter 02 is
shown, the display will read 0001. To maintain the chime mechanism, press the
s
now and go to P03. To
silence it, do the following:
To Change Parameter 2, Alarm On/Off
Press “Reset” once then release it. The display will begin to flash. Press
s
and hold it down, scrolling
down to 0000. Now “Reset” press once again. The chime is now deactivated. To reactivate the chime,
change parameter 02 back to 0001 using the same instructions provided above.
Now press
s
to reach Parameter 3 (P03), the Fan Delay or Post Session Cooling
P03
Parameter 3 is the fan delay. The fan delay maintains proper cooling of the ta nning unit by continuing to
provide power to the cooling fans for a programmable amount of time after the tanning session has
completed.
The unit comes with the fan delay preprogrammed at one (1) minute. Certain salon
conditions may warrant a higher fan delay to main tai n proper cooling. The fan delay cannot be turned o ff.
When parameter 03 is shown, the display will read 1.0 representing one minute. To change the fan dela y,
do the following:
To Change Parameter 3, Fan Delay
Press “Reset” once then release it, the display will begin to flash. Press either
s
or
t
to reach
desired setting. Time is displayed from 1.0 to 5.0, with decimal representing tenths of a minute. For
Example: 1.5 equals 1 minute, 30 seconds. After setting the fan delay press “Reset” once then
release it. The fan delay is now set.
NOTE: Fan Delay
The duration of the fan delay is not displayed on the timer while the fan delay is counting dow n. Tim e is,
however, displayed on the CCS-1 or the other control device during the fan delay to indicate how long the
fan delay has remaining. After a tanning session has expired, the ( _ _:_ _ ) will flash and the numeric
digits display will blink (off). If the Clean Room feature is on then along with the flashing colon (:) dashes
will appear in the display ( - - : - - ). When displayed on the CCS-1 or other control device the duration of
the fan delay counts down in three second decrements.
Note: When the Intellitan Plus timer is on a network no new time can be placed on the timer until af ter t he
fan delay has expired. The fan delay cannot be turned off.
Now press "up" to reach Parameter 4 (P04), the Session Delay function.
Parameter Detail