SunDash Radius 252, Operation & Assembly Instructions

Page: 16 / 40

15
Parameter Detail
P14
Parameter 14 is the measurement of the average ambient or room temperature during a previous session
or current session if the unit is energized. The reading is immediately displayed. Measurement is in
Fahrenheit.
Now press "up" once and release it to reach Parameter 15 (P15), the Clean Room feature.
P15
Parameter 15 is the clean room feature. When on, the clean room feature will show all dashes (- - - -) on
the timer display at the end of each tanning session to show that the tanning unit needs to be cleaned. In
network mode, no new time can be placed on the timer when the clean room indicator is displayed.
To reset the clean room feature from the room, indicating that the room has been cleaned, press the
“Reset” button twice in rapid succession. When the Clean Room feature is reset, the room timer will
display 00:00. The unit comes with the clean room feature off.
To Change Parameter 15, Clean Room Feature
Press “Reset” once then release it, the display will begin to flash. Now press "up" once to display 0001,
then press “Reset” once and release it. The Clean Room Feature is now enable d. To disable the Clean
Room Feature simply change parameter 15 back to 00:00.
Now press "up" once and release it to reach Parameter 16 (P16), the Econometer.
P16
Parameter 16 is the Econometer . The Econometer measures the electrical cost to power unit for previous
session or the current session if the tan ning unit is active. The cost displayed is derived from the session
cost per minute entered in P17. The reading is displayed immediately. Measurement is in cen ts and
tenths of a cent. This function is read only and can not be changed. Exa mple - A reading of 10.7 would
equal 10.7 cents.
Now press "up" once and release it to reach Pa rameter 17 (P17), Cost Per Session.
P17
Parameter 17 is the session cost per minute. This figure is automatically entered into the tanning units
data bank in accordance with the National Average of 7
.54 per kilowatt hour. The formula used is Unit
KwH Draw X National Average / 60 minutes = cost per minute. (Example 232G 3.1 x 7.5 / 60 = 0.388
rounded up to .4 cents per minute.)
To Change Parameter 17, Cost Per Minute
Press “Reset” once then release it, the display will begin to flash. Now press "up" or "down" until the
desired cost per minute is displayed. Measurement in cents and tenths of a cent. (Example: A reading
of .4 would equal four tenths of one cent.) Once the desired reading is displayed press once and
release it. The Cost Per Minute is now set.
Now press
s
once and release it to reach Parameter 18 (P18), the Session Counter.