SunDash Radius 252, Operation & Assembly Instructions

Page: 5 / 40

4
Care and Cleaning of Your Tanning Unit
After each session is completed, spray the
acrylic surface with specially formulated UVT
(ultraviolet transmitting) acrylic cleaner. Wipe
the surface of the acrylic with a clean cloth.
The acrylic should never be wiped with a dry
cloth because this will generate a slight static
charge which will attract dust. A mild liquid
detergent and water solution can be used
temporarily in place of Acrylic Cleaner.
For maximum efficiency of your tanning unit, periodic cleaning of lamps, reflectors and the inside
of the acrylics is required. Refer to relamping instructions for acrylic removal.
CAUTION: Do not use excessive amoun ts of water, any abrasive cleaners, or any spray cleaners
that carry label warnings regarding reactions to contact with skin!
DO NOT USE ALCOHOL OR AMMONIA
Electrical Safety:
The tanning unit should be disconnected from the power supply before cleaning of
disinfecting the inside of the acrylic. Avoid water or solution entering the lamp compartment.
Relamping Instructions
CAUTION:
Replacement lamps must comply with CFR21 1040.20
A. Replace only with “Genesis 2000 SHRX FR78-T12 SHRX-2”
B. When Ordering lamps, include model number and serial number.
Disconnect unit from power.
To remove acrylic from Panel D (Door Panel), locate the six (6) 1/4 turn fasteners on the acrylic re tainer
strip on the left side of the panel. Using a flat head screwdriver, turn each fastener a 1/4 turn counter
clockwise. You should hear a snap to release the strip. Repeat procedure on the remaining fasteners on
the retainer strip.
Lift edge of the acrylic approximately two (2) inches and slide acrylic to the left to remove.
Twist lamp 1/4 turn to disengage lamp from lampholder . Remove lamp. Repeat procedure for the
remaining twelve lamps in Panel D.
Relamp, clean and replace acrylic sheet. To install acrylic sheet, slide the entire length of the right edge
of the acrylic into the groove between the right rail and the acrylic the acrylic retainer strip. Flush the
acrylic with the groove in the rail, and secure with the lef t acrylic retainer strip. To attach the acrylic
retainer strip, align all six holes in the strip with the six holes in the left rail. Secure strip using a flathead
screwdriver. Turn each fastener clockwise 1/4 turn. You should hear the fastener snap to secure the strip.
Proceed to Panel C (next pa nel clockwise) and repeat procedures 2 through 5.
Upon completion of all the pa nels, reconnect unit to power.
1.
2.
3.
4.
5.
6.
7.