Sun Microsystems StorEdge L280, Manual

Page: 82 / 100

4-18 StorEdge L280 Service Manual • February 1998
AEH Time out moving the tape back into a slot after error A4.
This error could only happen if the loader controller tries
to move a cartridge from the slot onto the transport and
it fails. The loader controller would then try to move the
tape back into the slot. If it fails, this error occurs.
AFH Undefined error code.
B0H Undefined error code.
B1H Desktop mode.
B2H Door open without receiving a command. After power is
turned on, this command can occur as the loader
remembers the state of the door.
B3H Unit was reset or powered on.
B4H Time out prepositioning the transport during a
prepositioning command.
B5H Did not find all expected slots during transport
movements. This error can occur during a load or an
unload of a tape or a preposition command.
B6H Undefined error code.
B7H UART test failure.
B8H Undefined error code.
B9H Undefined error code.
BAH Undefined error code.
BBH Ram error.
BCH ROM error.
BDH CTC error.
BEH Undefined error code.
BFH Undefined error code.
TABLE 4-7
Error Codes (Continued)
Hex Error Probable Cause