Sun Microsystems StorEdge L280, Manual

Page: 71 / 100

Chapter 4 Administration, Diagnostics, and Troubleshooting 4-7
4.6 Configuring the Autoloader
1. To configure the Autoloader, press Next to enter the following:
2. In the
CONFIG *
menu, press Next or Prev until the name of the operation is
displayed, then press
Enter
.
If the selection has multiple settings, the current setting flashes.
3. Press the Next or Prev
button
until the desired setting is displayed.
4. Press the Next or Prev button to change the setting. Press Enter to select the setting.
OPTION SAVED
is displayed.
5. Press
Cancel
to move back up through the menus.
TABLE 4-2
describes the available configuration options.
ADMIN * / PSWD ### ### ### / CONFIG *
TABLE 4-2
Configuration Options
Config Name Description Default
RECOVERY ON/
OFF
Toggles between ON and OFF. If set to ON, the
Autoloader attempts to recover from errors. If set
to OFF the Autoloader stops moving if an error
occurs. Recovery should remain ON under
normal conditions. ON
RESTORE
DEFAULTS Sets all configuration options to their default
settings. —
CLEAR
ODOMETERS Sets all odometers to zero. —
NEW PASSWORD Enables the password to be changed. —
SCSI LOG ON/OFF Toggles between ON and OFF. Tracks internal
SCSI states and saves the information to a log. OFF
SECURE ON/OFF
Toggles between ON and OFF. When set to ON,
the door will not open. When set to OFF, the
door will open. OFF