Sun Microsystems StorEdge L280, Manual

Page: 36 / 100

1-12 StorEdge L280 Service Manual • February 1998
8. From the front of the bezel, slide the Autoloader into the shelf until it rests firmly
against the support bracket.
Note –
If you are installing a desktop unit into a rack, you will have to remove the
cover and feet. See Section 5.1, “Replacing a Unit,” on page 5-2 for the procedure.
9. Secure the unit by installing two M4x10-mm screws through the support bracket
and into the rear panel (
FIGURE 1-7
).
10. After connecting the external cables, secure the cables to the side of the rack by
following step 4 in Section 1.2.2, "Cable Management," on page 1-13.
Note – Save remaining screws for a possible second Autoloader installation.
FIGURE 1-7
Securing the Autoloader
Caution –
Be certain that the ambient of the rack cabinet does not exceed the
maximum room ambient of 104
o
F or 40
o
C.
!