Sun Microsystems StorEdge L280, Manual

Page: 38 / 100

1-14 StorEdge L280 Service Manual • February 1998
1.3 Connecting the Autoloader
Caution – Do not turn on the host system or connect power to the Autoloader
until these steps have been completed.
1. Properly shut down all peripheral devices connected to the host computer.
If the host computer is connected to a network, check with the system administrator before
switching off power.
2. Shut down the host.
3. Connect the long SCSI cable from the Autoloader to the host.
4. Connect the SCSI jumper cable to the two inside connectors on the Autoloader.
5. Ensure the SCSI terminator is installed as shown in
FIGURE 1-9
or
FIGURE 1-10
.
FIGURE 1-9
Autoloader as the Only Peripheral
TABLE 1-4
Description of Rear Panel Connections
1 SCSI cable to host SCSI port
2 SCSI jumper cable
3 SCSI terminator (differential)
!