Sun Microsystems StorEdge L280, Manual

Page: 41 / 100

Chapter 1 Getting Started 1-17
1.5 Moving or Shipping the Autoloader
1.5.1 Moving the Autoloader
1. Verify that a tape is not in the drive.
■
If using a software application to manage files in the Autoloader, check the
software documentation for instructions on removing tapes.
■
If not using a software application, use the
UNLOAD
top-level menu option.
■
If the drive is loaded with a tape, unload it before moving the Autoloader. Refer
to the backup software documentation or to “Opening the Door” on page 3-2..
2. Switch off power by unplugging the power cord from the back of the unit.
3. Shut down the host if necessary.
Note – Notify the system administrator before shutting down the host.
4. Remove the power cord and the host SCSI cable from the autoloader rear panel.
■
If the Autoloader is a desktop unit, lift it onto a cart and wheel it to its new
location. Go to step 6.
■
If the Autoloader is rackmounted, follow these steps:
Note – Keep all external accessories (cables and terminator).
a. Remove the two screws that secure the back of the Autoloader to the shelf. See
FIGURE 1-11
on page 1-18.
b. Remove the filler panel (if necessary), and slide the Autoloader out of the rack.
c. Move the Autoloader to its new destination.