Sun Microsystems StorEdge 6320 System 1.0, Reference And Service Manual

Page: 120 / 176

8-6 Sun StorEdge 6320 System 1.0 Reference and Service Manual • May 2003
FIGURE 8-3
Filler Panel and Trim Strip Location
6. If the system is not mounted to the floor, extend the stabilizer legs.
The stabilizer legs are located under the front of the system. Refer to the Sun
StorEdge 6320 System Installation Guide for detailed instructions.
Caution – Always extend or retract the stabilizer legs as a pair. Make sure that the
levelers have been adjusted before attempting to move the stabilizer legs.
7. Install the FRU.
Refer to the section Section 8.2, “FRU Locations” on page 8-3.
8. Route the power cables from the FRU to the power sequencer(s).
A system that is ordered without all possible FRUs installed has the power cables
routed as shown in
FIGURE 8-4
.
Trim strip
Filler panel
Installed FRU