Sun Microsystems StorEdge 6320 System 1.0, Reference And Service Manual

Page: 147 / 176

Chapter 12 Servicing Sun StorEdge 6020 Arrays 12-5
12.3 Replacing a Sun StorEdge 6020 Array
The instructions for replacing a Sun StorEdge 6020 array are broken into the
following subsections:
12.3.1 Preparing to Replace an Array
1. Note the MAC address of the replacement (new) array.
Tip –
Refer to Sun StorEdge 6020 and 6120 Arrays Installation Guide for instructions
about how to locate the MAC address.
2. Set the new Sun StorEdge 6020 array on a table and attach the side rails using the
eight screws provided.
3. Align the Sun StorEdge 6020 array’s rails with the rails inside the Sun StorEdge
6320 system, and then push the array into the cabinet.
4. Reinstall the four screws that secure the array to the front of the Sun StorEdge
6320 system.
Note –
Use care when installing the screws, as the weight of the array can cause the
screws to become cross-threaded.
5. Reattach the trim strips using the two screws on each side of the Sun StorEdge
6020 array.
6. Close the front door of the Sun StorEdge 6320 system.
7. Open the back door of the Sun StorEdge 6320 system.
8. Replace the four screws that secure the Sun StorEdge 6020 array to the side rails in
the back.
12.3.2 Connecting the Cables
1. Reconnect the two loop card cables on each side of the Sun StorEdge 6020 array.
2. Reconnect the Ethernet cable to the keepers.