Sun Microsystems Server X4-2, Installation Manual

Page: 76 / 208

62 Sun Server X4-2 Installation Guide • February 2014
FIGURE:
Location of Slide-Rail Release Tabs
b. Continue pushing the server into the rack until the slide-rail locks (on the
front of the server) engage the slide-rail assemblies.
You will hear an audible click when the server is in the normal rack position.
15. Connect cables to the server, as required.
Instructions for connecting the server cables are provided in “Cabling the Server”
on page 75 .
16. Open the CMA cable covers, route server cables through the CMA’s cable
troughs, close the cable covers, and secure the cables with the six Velcro straps.
Route the cables through the cable troughs in this order:
a. First through the front-most cable trough.
b. Then through the small cable trough.
c. Then through the rear-most cable trough
Note – When securing the cables with the Velcro straps located on the front slide bar,
ensure that the Velcro straps do not wrap around the bottom of the slide bar;
otherwise, expansion and contraction of the slide bar might be hindered when the
server is extended from the rack and returned to the rack.