Sun Microsystems Server X4-2, Installation Manual

Page: 158 / 208

144 Sun Server X4-2 Installation Guide • February 2014
■
You used Oracle System Assistant to create a volume and to make the volume
bootable.
■
Your server has the Sun Storage 6 Gb SAS PCIe Internal HBA (SGX-SAS6-INT-Z)
installed.
■
You only created one virtual drive using the LSI SAS2 BIOS Configuration Utility.
Before you begin this procedure, create at least one virtual drive, or RAID volume, on
the Sun Storage 6 Gb SAS PCIe RAID, Internal HBA (SGX-SAS6-R-INT-Z) using the
BIOS Configuration Utility (see
“Create a RAID Volume in Legacy BIOS Boot Mode
Using the BIOS RAID Configuration Utilities” on page 143 ).
1. Reset or power on the server.
For example, to reset the server:
■
From the local server , press the Power button (approximately 1 second) on the
front panel of the server to power off the server, then press the Power button
again to power on the server.
■
From the Oracle ILOM web interface , select Host Management > Power
Control, then select Reset from the Select Action list box.
■
From the Oracle ILOM CLI , type:
reset /System
The power-on self-test (POST) sequence begins.
2. While the BIOS is running the power-on self-tests (POST), and upon seeing the
prompt
Press <Ctrl><H> for WebBIOS...
, immediately press the Ctrl+H
key combination to access the LSI MegaRAID utility.
The Adapter Selection screen appears.