Subaru Legacy Outback 2006, Owner'S Manual

Page: 130 / 456

Instruments and controls
3-23
„
Turn signal indicator
lights
These lights show the operation of the
turn signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be
burned out. Replace the bulb as soon as
possible. Refer to the “Replacing bulbs”
section in chapter 11.
„
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also comes on when
the headlight flasher is operated.
„
Cruise control indica-
tor light (if equipped)
The cruise control indicator light comes on
when the ignition switch is turned to the
“ON” position and goes out after approxi-
mately three seconds.
This light comes on when the “CRUISE”
main switch is pressed.
NOTE
y
If you move the cruise control lever
or press the main switch button while
turning the ignition switch “ON”, the
cruise control function is deactivated
and the cruise control indicator light
flashes. To reactivate the cruise con-
trol function, turn the ignition switch
back to the “ACC” or “LOCK” position,
and then turn it again to the “ON” posi-
tion.
y
If this indicator light and the “ ”
indicator light flash simultaneously
during driving, we recommend that you
have the vehicle checked by your near-
est SUBARU dealer.
„
Cruise control set indica-
tor light (if equipped)
The cruise control set indicator light
comes on when the ignition switch is
turned to the “ON” position and goes out
after approximately three seconds.
This light comes on when vehicle speed
has been set.
„
Headlight indicator
light (Turbo and 3.0-li-
ter models except OUTBACK)
This indicator light comes on when the
light switch is turned to the “
” posi-
tion (to turn on the parking lights) or to the
“
” position (to turn on the headlights).
„
Front fog light indicator
light
This indicator light is on while the front fog
lights are on.
„
Rear fog light indicator
light
This indicator light is on while the rear fog
lights are on.