Sturtevant Richmont Global 400, User Manual

Page: 65 / 85

Global 400 User Manual 65 of 85 v1.1 revision 1
Chapter 7: EtherNet/IPTM 2 February 2016
C.E. Parameter Object
Class Code: 65 Hex
The C.E. Parameter Object refers to a parameter that describes the required operation for a batch
of tightenings. This should not be confused with the Parameter Object (class code 10 hex)
defined in the open portion of the Ethernet/IP
TM
protocol, which has a different use and is not
implemented in this product line.
Class Attributes
ID Access Name Data Type Description of Attribute Semantics of Value
1 Get Revision UINT Revision of this object 1
2 Get Max Instance UINT Maximum instance number
of a parameter set object in
the device. The maximum number of
parameters as specified
for the product.
Instance Attributes
ID Access Name Data Type Description of Attribute Semantics of Value
1 Set Name SHORT_STRING Name of the parameter
displayed on screen and
reported in results
Maximum length is 25
characters
2 Get Last Modified DT Last time the parameter
attributes were modified
3 Set Tool UINT Instance number of tool
used for this parameter
4 Set Holding Tool UINT Instance number of holding
tool used for this parameter
5 Set Batch USINT Batch size
6 Get Number of
Batches UINT Number of batches run in
this parameter This value resets on
powerup.
7 Set
1
Timer Min ITIME Minimum hold time for a
valid click. Range T#0s000ms –
2s550ms
8 Set
1
Timer Max ITIME Maximum hold time for a
valid click Range T#0s000ms –
2s550ms
9 Set
1
Time Between
Cycles UDINT Minimum amount of time
required between results Range T#0s000ms –
65s536ms
10 Set
1
Time Between
Batches UDINT Minimum amount of time
required between the last
result of a batch and the first
result of the next batch Range T#0s000ms –
65s536ms
11 Set
2
Torque Unit ENGUNIT Unit of measurement for
toruqes
12 Set
2
Torque Min REAL Minimum torque for a valid
tightening.
13 Set
2
Torque Max REAL Maximum torque for a valid
tightening.
14 Set
2
Torque Direction USINT Allowed torque direction for
a valid tightening. One of:
0 = positive
1 = negative
2 = both
15 Set
2
Torque Mode USINT Mode used to measure
torque. One of:
0 = peak
1 = residual
16 Set
2
Angle Min UDINT Minimum angle for a valid Reserved for future use