Global 400 User Manual
19 of 85
v1.1 revision 1
Chapter 2: Using the unit
2 February 2016
Rundown Graph
Figure 7: Rundown Graph screen
Function keys
1.
EDIT – Go to the Parameter Edit screen for the running parameter. This will require the
password to be entered.
2.
No function
3.
REFRESH – Refresh the graph with the data for the most recent run of the tool.
4.
RETURN [ESC] – Returns to the Unit Status Screen.
The Rundown Graph screen retrieves and shows the last rundown from an air tool. The rundown
will be overlaid with yellow horizontal lines for each of the three thresholds and vertical lines
showing the timers, purple for Timer Min and Timer Max, blue for Timer Clutch. Additionally,
the total time for the rundown is shown at the right end of the horizontal axis.
Network Status
Figure 8: Network Status screen
The network status screen shows the current Ethernet status
of the unit. The MAC address is assigned by the factory
and cannot be changed. The IP address, subnet mask, and
gateway may be edited from the Network Setup - General
screen or assigned via DHCP.
The Ethernet 1 and 2 lines indicate if a physical cable
connection is detected on the corresponding Ethernet ports
of the unit. If no connection on a port is detected, the unit
will show “Not connected”. If a connection is detected, the
baud rate and duplex of the connection will be listed.
