Global 400 User Manual
25 of 85
v1.1 revision 1
Chapter 3: Configuring the unit
2 February 2016
Tools
Tools in the Global 400 are divided into two groups, primary and holding tools. Primary tools
are those that can perform tightenings, such as click and digital tools. Holding tools cannot
perform a tightening themselves and are only used along with a primary tool. The Global 400
allows you to learn up to 16 primary tools and 8 holding tools. While each set of tools gets a
separate screen, the processes for learning and editing them is similar.
Figure 15: Main menu - Tools
Figure 16: Tools Menu - Tools
Figure 17: Tools Menu - Holding
Figure 18: Learned tool selected
Figure 19: Empty slot selected
Figure 20: Holding tool selected
Function keys
When a learned tool is highlighted, the function keys are:
1.
REPLACE – Learn a new tool in place of the current tool in this slot. If you cancel out of the
learn sequence, the current tool will remain in the slot.
2.
EDIT [ENT] – Go to the Tool Edit screen, which is discussed below, for the selected tool.
3.
LEARN OPEN – Starts the learn sequence for the empty tool slot with the lowest number.
4.
RETURN [ESC] – Returns to the main menu.
When an empty tool slot is highlighted, the function keys are:
1.
LEARN [ENT] – Starts the learn sequence for the highlighted tool slot.
2.
No function
3.
LEARN OPEN – Starts the learn sequence for the empty tool slot with the lowest number.
4.
RETURN [ESC] – Returns to the main menu.
Tool Configuration
Depending on the type of tool, the Tool Edit screen will have a slightly different set of fields.
