Stryker 2941-000-004, Operation Manual, Page: 38 / 452

IIsso oA Aiirr ssyysstte em m iiss ssu uiitte ed d ffo orr u usse e iin n tth he e e elle eccttrro om ma ag gn ne ettiicc e en nvviirro on nm me en ntt ssp pe ecciiffiie ed d b be ello ow w.. T Th he e ccu usstto om me err o orr tth he e u usse err o off
IIsso oA Aiirr ssyysstte em m ssh ho ou ulld d m ma akke e ssu urre e tth ha att iitt iiss u usse ed d iin n ssu ucch h a an n e en nvviirro on nm me en ntt..
IIm mm mu un niittyy T Te esstt
IIE EC C 6 60 06 60 01 1 T Te esstt
L Le evve ell
C Co om mp plliia an ncce e L Le evve ell E Elle eccttrro om ma ag gn ne ettiicc E En nvviirro on nm me en ntt -- G Gu uiid da an ncce e
Conducted
RF IEC 61000- 4-6
Radiated RF
IEC 61000-4-3
3 Vrms
6 Vrms in ISM bands
150 kHz to 80 MHz
10 V/m
80 MHz to 2.7 GHz
3 V
6 V in ISM bands
10 V/m
Portable and mobile RF communications
equipment should be used no closer to any
part of IIsso oA Aiirr, including cables, than the
recommended separation distance calculated
from the equation appropriate for the
frequency of the transmitter.
Recommended Separation Distance
d=(0.35)√
P
80 MHz to 800 MHz
d=(0.70)√ P
800 MHz to 2.7 GHz
where P is the maximum output power rating
of the transmitter in watts (W) according to
the transmitter manufacturer and d is the
recommended separation distance in meters
(m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site
survey a , should be less than the compliance
level in each frequency range b .
Interference may occur in the vicinity of
equipment marked with the following symbol:
N No otte e -- At 80 MHz and 800 MHz, the higher frequency range applies.
N No otte e -- These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects, and people.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile
radios, amateur radio, AM and FM radio broadcast, and TV broadcast cannot be predicted theoretically with accuracy. To
assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be
considered. If the measured field strength in the location in which IIsso
oA Aiirr is used exceeds the applicable RF compliance
level above, IIsso oA Aiirr should be observed to verify normal operation. If abnormal performance is observed, additional
measures may be necessary, such as reorienting or relocating IIsso oA Aiirr.
b
Over the frequency range 150 kHz to 80 MHz, field strengths are less than 3 V/m.
EN 34 2941-009-005 Rev A.0