Still RX60-60, Original Instructions Manual

Page: 187 / 408

The load measurement has an accuracy of
+/-3% of the rated capacity of the truck.
NOTE
In order to ensure accuracy at all times, a zero
adjustment of the load measurement must be
carried out. Zero adjustment is required.
●
as part of daily commissioning
●
after changing the fork arms
●
after fitting or changing attachments.
Performing the load measurement
DANGER
Risk of accident from a falling load!
The load may fall if the load centre of gravity has not
been taken into account or the load has not been
picked up securely.
–
Pick up the load securely; see the chapter entitled
"Picking up loads".
CAUTION
If the weight determined by a load measurement ex-
ceeds the permissible residual load capacity of the
truck, the truck cannot be operated safely.
–
Set down and reduce load immediately.
–
If necessary, use another truck with sufficient
load-bearing capacity.
NOTE
Accurate load measurement is only possible
under the following conditions:
●
The hydraulic oil is at normal operating tem-
perature
●
The load is at rest at the beginning of the
load measurement
●
The load corresponds to at least 10% of the
nominal load capacity in trucks with a load
capacity of up to 2.5 t
●
The load corresponds to at least 5% of the
nominal load capacity in trucks with a load
capacity of 3 t and over
●
The lift mast is in the vertical position
●
The fork is not raised to more than 800 mm
above the ground
Operating
4
Handling loads
175 56358042501 EN - - 11