NOTE:
When troubleshooting, always check for
correct voltage, current, and resistance as specified
by the machine's data plate. Before troubleshooting
machine, verify that the control board assembly is
programmed to operate as an SD3.
VERIFY CONTROL BOARD is
CONFIGURED as an SD3
1.
Turn dishwasher off.
2.
Press the ON key on the switch membrane
keypad.
A.
Control board/display will begin a self-
check. When self-check completes,
machine type will be displayed briefly.
1)
AP (plain - external booster).
2)
AH (hot - self-contained booster).
3.
If machine type programmed into control board is
other than machine type on data plate, the control
board must be programmed before continuing.
Refer to CONTROL BOARD PROGRAMMING
as outlined in SERVICE PROCEDURES AND
ADJUSTMENTS.
4.
Check machine operation to see if problem still
exists.
ERROR CODE CHART
ERROR CODE CHART
Error Code
Explanation
Troubleshooting
E3
E1 - After wash cycle.
NOTE:
Shows Pd
while washing
1:15 cycle no rinse - E1
E2
Water did not reach the float during a
fill within 150 seconds.
Ensure drain lever is closed and the standpipe is
properly seated. Verify float is clear of debris.
Ensure the incoming water valve is open and water
flow/pressure is 20psi (+/- 5psi).
E6
Float and temperature thermistors
could not be detected.
Verify operation of float and temperature
thermistors. Ensure thermistor and door switch plug
is connected to J2 on control board.
Ed
Slow Leak. Machine enters fill cycle
three times with 35 minutes of initial
fill.
Ensure drain lever is closed and the standpipe is
properly seated with the O-ring clear of food soils
or other debris.
EE
Booster did not reach temperature
within eight minutes after initial fill.
Check to see that booster power is on. Check that
the water heater is on and supplying proper hot
water (min of 110°F).
EF
Severe internal control error.
Control board malfunction.
P1
Open or shorted wash tank
thermistor.
Check thermistor and switch thermistor and wiring.
P2
Open or shorted rinse thermistor.
Check rinse thermistor and wiring.
P3
Open or shorted booster thermistor.
Check booster thermistor and wiring.
TROUBLESHOOTING TABLE
NOTE:
Before troubleshooting machine,verify that
control board assembly is programmed to operate as
an SD3. Refer to CHECKING CONTROL BOARD
CONFIGURATION as oulined in this section.
SD3 Series - TROUBLESHOOTING
Page 35 of 37
F45576 (1015)
Summary of Contents for SD3 Series
