Steca coolcept StecaGrid 1500, Installation And Operating Instruction

Page: 18 / 94

n
Max. daily yield
: The maximum daily yield achieved 3)
n
Operating hours
: The operating hours during which the
device has been connected to the grid (including night-time
hours).
n
Total yield
: Yield since commissioning
n CO
2
savings
: CO
2
savings achieved since commissioning
1) Measurement is always displayed (cannot be switched off)
2) Possible causes:
– Internal temperature too high
– User default Power limiter
– Frequency too high
– Controlled by grid operator (feed-in management)
– Delayed increase in power after starting
3)
Can be reset to 0 via
Settings
▶
Reset max. vals.
An acoustic alarm sounds (approx. 4.5 kHz) when an event message
is displayed.
n
2 Sounds: Warning
n
3 Sounds: Error
The acoustic alarm is switched off with the factory default settings.
n
off
n
automatic
: Switches on for 30 seconds when a button is
pushed
n
Grid feed:
(factory setting)
– Not feeding: Switches on for 30 seconds when a button is
pushed; then switches off
– Feeding: Switches on for 30 seconds when a button is
pushed; then dims
Notice
–
A prerequisite for this is that you know the
parameters required for setting up the TCP/IP
network connection. Consult (further) technical
professionals if required.
– DHCP is activated in the device ex-works. This
allows automatic integration of the device in
most networks.
Network settings, required for network communication, e. g. with an
Internet portal:
n DHCP
: Switch DHCP on/off
n
IP address
: IP address of the inverter
n
Subnet mask
: Subnet mask of the inverter
n
Gateway
: IP address of the network gateway
Acoustic alarm
Backlight
TCP/IP network
EN
747,431 | Z09.2 | 18/02/2016 18