Q
No Bill Acceptor Shutdown
(The Factory Default Setting for No Bill Acceptor Shutdown is “NO”).
To make a change to the No Bill Acceptor Shutdown feature, follow the step by step procedure outlined
below.
Note: The five-position switch and red selection button are located on the dispenser control board of
the device marked “Primary”.
IMPORTANT: Please note the original switch settings before starting this procedure. You will need to
return the switches to this original setting to assure proper operation after making any changes. As a
convenience, you can enter these original settings in the diagram to the right by simply
marking an “X” for UP or DOWN on each switch.
1.
Activate the No Bill Acceptor Shutdown programming mode by setting:
Switch 1–ON; Switch 2-OFF; Switch 3-OFF; Switch 4-ON; Switch 5-ON
2.
Press the red selection button one time.
3.
Advance to the No Bill Acceptor Shutdown selection step by setting; Switch 1-ON; Switch 2-
OFF; Switch 3-OFF; Switch 4 –OFF; Switch 5-OFF
4.
Press the red selection button Twenty times.
5.
Now set switches to desired setting Choice numbers 1 or 2 from the table below. Example: Set
switches to match Choice 2 if you want the No Bill Acceptor Shutdown set to yes. Once you’ve
made your selection, press the red selection button one time.
6.
End the programming sequence by resetting the switch to their original settings, and then press
the red selection button one time to put the machine back into service.
NO BILL ACCEPTOR SHUTDOWN CHOICES
CHOICE
SETTING
SWITCH POSITIONS
SW2
SW3
SW4
SW5
1
NO
UP
UP
UP
UP
2
YES
DOWN
DOWN
DOWN
UP
12 345
