31
5.21
Dispenser Value (Feature Type = Device)
Default Settings = $00.0
This feature allows you to set a dispenser value other than those listed in the
DISPENSER VALUE SETTINGS
table shown in the Operating Mode section of this manual. This allows you to set the value to anything
between $0.05 and $99.95, in nickel increments. This would typically be used for ticket, token or card
dispensers. Some machines are equipped with a multi-cassette bill dispenser. The value of each cassette
is setup using this feature. The value is for one item.
The method used is one whereby you set the four digits (of the value) starting with the tens digit of the
dollar amount. For this value to be used, all the switches (SW1-SW5) must be in the DOWN position
when you exit the
Configuration Mode
.
This is the only case where you would not return the dip
switches to the operating mode settings.
If any of the switches are up, the DISPENSER VALUE
SETTINGS will override the value you have set in these steps; the value is still there, however, it will just
not be used.
Multi-Cassette Bill Dispensers- If the machine is equipped with a multi-compartment bill dispenser
(Fujitsu F53), the value of each cassette will need to be setup. Note - Any cassette that does not have a
value programmed will not be used for the dispense cycle and will not appear in the Configuration Report
on an Extended Function module. Steps 1-4 are used for the top cassette, steps 5-8 are used for the next
one down, steps 9-12 are used for cassette the next one down, steps 13-16 are used for the next one down,
etc.
Example for setting the value of a $5.00 bill cassette located in the top position of the dispenser:
Steps 1 –
Enter the tens digit for the dollar amount
$0 _._ _
Steps 2 –
Enter the ones digit for the dollar amount
$_ 5._ _
Steps 3 –
Enter the tens digit for the cents amount
$_ _.0 _
Steps 4 –
Enter the ones digit for the cents amount
$_ _._ 0
Setting the value for Step 4 is different than steps 1-3 in that you can only set it in nickel amounts. This
means that the last digit can either be a zero or a five. As an example you cannot have a dispenser value
of $12.77. It has to be either $12.75 or $12.80.
5.22
Ticket Coast Time (Feature Type = Device)
Default Settings = 50 msec
This is the amount of time the ticket device will remain on even after the last ticket notch is detected. This
is useful if you would like to leave a little extra ticket sticking out the front of the machine. Caution should
be taken to avoid excessive coasting as ticket tearing can occur.
