4
1.0
QUICK START GUIDE
Your machine has been shipped preprogrammed from the factory. All settings will be programmed to the
factory default unless otherwise specified at the time of order. The majority of new machine owners need
only read this section in order to learn the basic installation and operating features of your machine. For
more detail, or if you just enjoy reading technical information, see the remaining sections of this manual.
1.1
Placing The Machine
The machine should be located in an area where it can be easily bolted to the floor or to a wall
for security purposes.
The door should be able to swing fully open and not come in contact with anything else. This
allows easy access for filling the hoppers and removing the deposited money. Some models
require a full 180-degree door swing to allow the hopper contents (coins) to be manually
dumped.
If the machine is to be installed in an outdoor location, we recommend a Rear Load model
changer. The machine should be located in an area where it will not be directly exposed to the
elements: excessive dust/dirt, direct sunlight, and/or direct rainfall. We recommend the use of
a canopy over the machine to ensure a longer trouble-free service life as well as to provide a
convenience for your customers.
The machine power cord should be secured in a manner that will prevent accidental or
intentional unplugging.
1.2
Removing The Internal Shipping Restraints
Internal shipping restraints are typically used to secure the internal machine components during shipping.
The restraints used are of various types: shipping tape, shipping brackets or shipping bars. Shipping
brackets and bars can be identified by a label with the marking indicating their purpose. These should be
removed to allow full access to each device. See examples of shipping restraints below.
!!!! CAUTION !!!!
Always disconnect the 24V power supply(s) before adding or removing a module.
Failure to do so can result in corrupt data and premature component failure.
SHIPPING BAR – F50
FUJITSU
BILL DISPENSER
SHIPPING TAPE ON
BILL
ACCEPTOR
SHIPPING BRACKET-MC900
COIN DISPENSER
REMOVE BOTH
HEX. NUTS
