Diagnostics and Fault Finding
7-1
631 Digital Servo Drive 07-01-08-02-E-V0500
7
D
IAGNOSTICS AND
F
AULT
F
INDING
The seven-segment display is
illuminated when the servo drive is
powered-up. It provides information on
the state of the drive, active trips, and
assists in fault finding.
Remember to remove the protective film
covering the display when installing the
drive.
Figure 7-1 Diagnostic Display
Resetting a Trip Condition
There are two options:
1.
Switch the supply voltage OFF and ON
2.
Use EASYRIDER
<
Trip Diagnostics
Display
Display
Display
Display Explanation
Explanation
Explanation
Explanation
Ready *
Ready *
Ready *
Ready *
(output X10.5)
Warning *
Warning *
Warning *
Warning *
(output X10.6)
Comment
Comment
Comment
Comment
no display
off
off
Is the supply voltage present?
Are the external fuses ok?
system ready to operate
on
off
regulator ready
not active
system active
output stage active, no interference
internal stop
deactivation via serial interface
off
off
•
Re-start the drive
or perform a RESET and activate
the drive
Internal stop
-
-
Deactivation via BIAS command
Active input is activated
with
switching on
off
off
•
Switch ACTIVE X10.7
to Low and then to High
X
2
1
X
4
1
X
2
0
X
4
0
X 3 0
X15 /RS232
Diagnostic
Display
