41
Shock Assembly and Bleed
RC3 and RTR:
Install the compression assembly into the reservoir
mount. Push the compression assembly into the reservoir until it stops.
Check that the compression lever is still in the unlocked (min) position
so the compression needle does not block oil flow through the valve.
RTR:
Use a pick to verify the lock shim is correctly installed. Insert the
pick into the refill holes on the compression assembly to make sure
the lock shim is able to flex. If the lock shim is not able to flex, remove
the compression assembly, straighten out the shim, then reinstall the
compression assembly.
Thread the IFP reservoir onto the eyelet. Tighten the IFP reservoir to
8 N·m (70 in-lb).
Install the crowfoot onto the torque wrench at a 90° angle to the
handle to ensure an accurate torque reading.
2
3
31 mm
8 N•m (70 in-lb)
4
