35
Remote Spring Replacement - RTR Only
Preload the spring clockwise until the threaded hole in the cam aligns
with the hole in the cam housing, then install the travel limit screw and
tighten until the screw is flush. Carefully unload the spring.
Place tension on the spring by preloading and unloading it to ensure it
has been installed correctly.
⚠
CAUTION
If not unloaded slowly, the spring can reset rapidly, causing the hex
wrench to eject from the cam assembly.
Spray isopropyl alcohol on the remote subassembly and clean it with
a rag.
Install the remote subassembly into the reservoir mount. The machined
flat will only allow the remote subassembly to be installed one way.
Use a torque wrench with a 3 mm hex bit socket to tighten the cap
screw to 2.1-2.5 N•m (18-22 in-lb).
5 mm
T10 TORX®
1.1 N•m (10 in-lb)
8
5 mm
1.5 mm
5 mm
5 mm
9
3 mm
2.1-2.5 N•m (18-22 in-lb)
10