51
Air Can Installation
Press the air can onto the damper then thread it onto the shaft eyelet
until it is hand tight.
Spray isopropyl alcohol on the outside of the air can and clean it with
a rag.
Remove the shock from the vise. Turn it over and clamp the damper
body eyelet in the vise.
Stabilize the air can with a strap wrench to prevent it from rotating.
Tighten the air can to 4.5 N
m (40 in-lb).
Remove the shock from the vise. Spray isopropyl alcohol on the shock
and clean it with a rag.
Install the sag indicator o-ring.
4
Strap wrench
4.5 N·m (40 in-lb)
13 mm
5
6
7
