INSTALLATION
The Wall Bracket can be used in two ways: to attach the
Workstation to a wall, or to provide a slight tilt for a flush counter-
mount installation.
WALL MOUNT
Mounting screws MUST be secured into the wall stud. (Two
screws are sufficient for vertical studs.) “Butterfly Shield screws”
must be used for gyproc to ensure that the bracket doesn’t pull
away from the wall causing the Workstation to fall.
See Appendix H for the use of “Butterfly shield” type screw.
Mounting flanges on the Wall Bracket hold and support the
Workstation. A foam insert is included as a spacer to prevent
unintended dislodging of the WS from the bracket, while still
allowing easy service access. Place the Workstation on the
bracket as shown in Figure 3-7.
Figure 3-7. Wall Mount
The rubber feet on the backside of the Workstation may have to be
removed for it to be wall mounted.
Mounting the Workstation 8 to a Wall Bracket (92-207)
Foam Insert
#98-302
Foam Insert
(“Bump-off”
Preventer)
#98-302
3-8 Preliminary Release
3/24/05