DISASSEMBLY AND ASSEMBLY
NO T E
5. Adjust and position the LCD, then tighten the screws using a
crisscross pattern. DO NOT USE POWER TOOLS, ONLY HAND
TIGHTEN THE MOUNTING SCREWS.
Binding Torque Value: 0.196N x m (2.0Kgf x cm)
6. The pink and blue wires of the LCD’s backlight cable connect to Pin
1 of interface connectors J2 & J3 on the Inverter Board.
Base Bottom Disassembly
Disconnecting the Power Switch Cable from the Motherboard
1. Disconnect the power switch cable from the quick tabs located on
the motherboard.
NO T E
NO T E
2. Cut the cable tie strap securing the ferrite bead to the Rear Internal
Shield Casing.
When disconnecting cables, DO NOT PULL on the cable itself.
Remove/disconnect the cables by pulling on their connector or pull-
tab.
2. Cut the cable
tie strap securing
the ferrite bead
1. Disconnect the power
switch cable from the
quick tabs.
3. Pull back the power switch cable until the cable is clear of the
slot/channel on the Rear Internal Shield Casing.
Attention needs to be paid as to how the power switch cable was
routed and how the ferrite bead was positioned when secured to
the Rear Internal Shield Casing.
2-18 Preliminary Release
3/24/05