DISASSEMBLY AND ASSEMBLY
Reassembly
Reassembly is the reverse of the disassembly process.
Disassembly of the Internal Shield Assembly
Removing the Internal Shield Assembly out of the Base Bottom Plastics
1. The Internal Shield Assembly sits inside the Base Bottom Plastic
Housing and is not secured to the Bottom Plastic Housing in any way.
To remove the Internal Shield Assembly, grasp the assembly as shown
in the picture below and carefully lift the assembly straight out of the
base bottom evenly.
Reassembly
Reassembly is the reverse of the disassembly process. Simply align the
Internal Shield Assembly to the Base Bottom Housing and carefully lower
the Internal Shield Assembly into the Base Bottom Housing. Check to make
sure the Internal Shield Housing is sitting evenly inside the Base Bottom
Housing.
Removing the Power Switch Cable and the Power Switch
NO T E
1. Disconnect the power switch cable from the tabs of the power switch.
When disconnecting cables, DO NOT PULL on the cable itself.
Remove/disconnect the cables by pulling on their connector or pull-tab.
3/24/05
Preliminary Release 2-19