INSTALLATION
Figure 3-6. Tilt Stand Base Setscrews.
Set Screws (3)
(1/8” Allen key)
3. Using a 1/8" Allen Key, loosen these screws just enough so that
the back-plate of the stand begins to move. While holding the
stand against the mounting surface, adjust the back-plate to the
angle desired. On a piece of masking tape placed on the raised
portion of the base by the back-plate, mark the desired back-
plate angle with a felt pen. The back-plate angle can now be set
by tightening the setscrews using the mark on the tape as a
guide for the desired angle. (Don't forget to remove the tape
afterwards.)
4. If needed, the tilt angle range can be switched over to the
opposite side of the base. Remove the setscrews and lift the
back from the base. Flip the back 180° and re-install it into the
base. Replace the washers, adjust the back to the desired angle
and tighten the setscrews.
5. Place the stand in its previous location and fasten the base
screws.
6. Install/mount the Workstation 8.
3/24/05
Preliminary Release 3-7