DISASSEMBLY AND ASSEMBLY
Front/Top Plastic Cover
10.25” RF Gasket Strip (2 pcs)
(99-622)
(88-053-1)
Touch strip
(on front side)
(99-623)
Backside View
In the event the top cover is damaged and is required to be replaced, it should
be noted that the top cover consists of the following: Top cover plastic, RF
Gasket Strips and the Touch Strip located in front of the cover.
When ordering, all 3 items need to be ordered at the same time. The gasket
and Touch Strip are not reusable. When installing the gasket, DO NOT stretch
the gasket during application.
Reassembling the top cover to the bottom housing is the reverse of the
disassembly process. When the top cover is fitted over the bottom housing,
make sure the Badge Reader’s Card Guides fit into place in the Badge Card
Slot located in the Font Cover.
Replacing the Front
Cover
Badge Card Slot
Magswipe Card Slot
7.35” RF Gasket Strip
(2 pcs)
(88-053-2)
Removing the
Magswipe Reader
1.
To remove the Magswipe Reader
a
#1 Phillips screwdriver is
required.
2. When disconnecting the interface cable from the ISIS
Detector board, attention should be paid as to how the
connector is oriented and connected to the right angle
connector on the detector board.
3/24/05
Preliminary Release 2-7