DISASSEMBLY AND ASSEMBLY
2. Gently push the switch through the Base Bottom Housing until the
switch pops out.
Reassembly
Reassembly is the reverse of the disassembly process.
Removing the Intake Fan
1. Disconnect the fan’s 3-pin connector plug from the 3-pin header
(Reference Designator: CN2) on the motherboard.
CN2
2. The fan is secured via two #6-32x1/2” Phil screws (as depicted below)
onto PEM Head Standoffs located inside the Shield Housing. To remove
the fan use a #1 Phillips screw driver and carefully unscrew the top screw
first followed by the remaining screw.
FAN ASSEMBLY
82-608
6-32x1\2” Phil Screw (x2) Black
Located on top corner (unscrew first)
& bottom corner (unscrew last)
2-20 Preliminary Release
3/24/05