Spectra Watermakers Catalina 340 Z, Installation And Operating Manual

Page: 16 / 90

16
Sea Strainer and Boost Pump Module: Mount
close to the intake through-hull in a location
that can handle water spillage during service.
The boost pump cable will connect to the feed
pump module.
Z-Ion or Fresh Water Flush Module: The Z-Ion or fresh wa-
ter flush module (both contain the charcoal filter for fresh
water flushes, but the Z-Ion has added sterilization) may be
located in any convenient location near the feed pump
module. It should be mounted with the filter housing verti-
cal and accessible for changing filters, with 2” below the
housing for filter changes. Do not install over electrical
equipment. The unit contains the charcoal filter, a solenoid
shut off valve, and a flush water flow regulator. SEE PAGE
29 FOR Z-ION INSTALLATION AND INSTRUCTIONS.
Introduction to Components continued...
Remote Control Panel: Can be mounted anywhere that is dry
and convenient. Cut a 4-9/16” (116 mm) wide by 2-7/8” (68mm)
high opening for the panel. Take care when routing the cable so
the plugs on each end are not damaged. Use only Spectra ap-
proved remote cable. The cable is not a standard LAN cable or
phone cord.