Spectra Watermakers Bimini 300, Installation And Operating Manual

Page: 5 / 78

5
Fresh Water Flush
Pressing the ‘ Fresh Water Flush ’ button flushes
the watermaker with fresh water from the ves-
sel ’ s domestic water tanks. After completing
the flush, Spectra Connect will automatically
enter the Auto Store mode.
Stop
Pressing the ‘ Stop ’ button from the Home
Screen will end the Auto Store mode count-
down timer and leave your watermaker in
Standby mode.
When you first power up the system, you will get a warning message, asking if the system has
been stored with chemicals.
If the system has been pickled, winterized, this is the first startup, or the condition of the sys-
tem is unknown, go to COMMISSIONING on page 23 or serious damage may occur.
Start
Pressing the ‘ Start ’ button once advances to
the Run Mode selection screen.
Spectra Connect Quick Start Guide
Run Mode
Select your desired Run Mode to start making
water and filling your tanks. See details on Run
Mode options on p. 37
Spectra Connect Modes and Definitions
Auto Store: After the watermaker fresh water flushes, it will start a countdown timer that can be
seen on the Home screen. The timer indicates the next programmed fresh water flush if the water-
maker is not started again, or the ‘ Stop ’ button is not pressed.
Fill Tank : The watermaker will automatically run until the Tank Full switch in the water storage
tanks closes. Once the Tank Full switch closes, the watermaker automatically fresh water flushes,
then reverts to the Auto Store mode.
Auto Run: The watermaker can be set to run for a number of hours, or for a quantity of water to be
produced. When the desired quantity of water is produced or the run timer expires, the watermaker
will Fresh Water Flush and enter the Auto Store mode.