Spectra Watermakers Bimini 300, Installation And Operating Manual

Page: 38 / 78

38
If the system has been pickled or stored with chemicals, use the New System Startup pro-
cedure on page 23.
Your watermaker will fresh water flush after every use . Remember that you need to run the
system approximately half an hour to make enough fresh water for one flush.
You may notice that the system output is higher when charging your batteries. This is normal.
1. Check to see that the inlet and brine discharge seacocks are open and the domestic pressur-
ized water system is turned on.
2. Press the ‘ Start ’ button, then select the desired operating mode.
Runs your watermaker until the Tank Full switch closes, fresh water flushes the
system, then goes into ‘ Auto Store ’ mode and the Flush Interval timer starts.
This is the default mode of operation.
Gives you the option to run for a preset amount of time, or a preset volume of
water to be produced. If no tank switches are installed, and they have been
disabled in the system settings , this is the only Operating Mode available.
Normal Operation
Standard Operating Modes
Enter Volume or Time
Select Gallons/Liters or Hours
Starts the Wa-
termaker