Spectra Watermakers Bimini 300, Installation And Operating Manual

Page: 24 / 78

24
Factory Supplied Tank Full Switch
Installing the supplied tank full float switch at the top of your water tank al-
lows the Spectra Connect to fill your water tank then automatically stop, fresh
water flush and return to Auto Store mode with no additional user commands.
Note: The float may need to be flipped 180
°
to work properly. The float can
be easily flipped by removing the clip opposite the wire.
Drill and tap a 1/8” npt port into the top of the fresh water tank that is being
filled by the watermaker. This can be installed on a tank access cover, or
directly into the water tank. If installing on an access cover, be sure to leave a
service loop on the float switch wiring to allow removal of the tank access cover.
For Instructions on ‘ Auto Fill ’ mode and installing a Tank Low switch, see ‘ Auto Fill ’ mode
instructions later in this manual.
Watermakers should never be run unattended.
Your watermaker comes with the top - mounted Tank Full Switch (EL - SWT - LV) and is de-
signed to be mounted to the top of the water tank. The side - mounted float switch (EL - SWT -
SMLV) can be sourced from your local dealer or Full Service Provider if you cannot access the
top of your tank.
If you do not install the Tank Full switch in your tank, you MUST DISABLE the Tank Full
Switch in the system settings. See System Settings instructions later in this manual.
Tank Switch Installation
The supplied float switch must be connected to the Green and Orange conductors at the Feed
Pump Module, labeled Tank Full Switch. There is no polarity.
Use 18/2 tinned wire or larger. Wire is not included in the installation kit.
Drill and Tap
Connect to Gr/Or wires