Spectra Watermakers Bimini 300, Installation And Operating Manual

Page: 21 / 78

21
Bimini 300 systems are pre - fitted with waterproof connectors for electrical and signal ca-
bles. Each connector is different, so it is impossible to connect them incorrectly, and the con-
nectors are color
- coded. The system has a power inlet harness with a terminal block and cov-
er, a 2 - conductor boost pump cable, a 5 - conductor diversion valve and Rotoflow sensor cable,
a 2 –conductor fresh water flush solenoid cable, a Z - Ion power and signal cable, and a 100 - foot
(30.5 M) cable for the Connect display.
Diversion Valve and
Rotoflow Cable (5
-
conductor, Red).
Z - Ion power and signal
cable (3 - conductor,
Green)
Cables are shown coming
out of the bottom of the
Feed Pump Module
.
Fresh water flush sole-
noid cable (2
- conductor,
Blue)
100’ (33.3M) cable with
connectors for the connect
display
The Bimini 300 has three ports that
can be viewed when looking down
inside the Feed Pump Module; one
for the display, one for networking,
and one for the salinity probe. The
Salinity probe is a 5 pin cable with RJ
- 12 connectors (phone jack) on both
ends this cable runs in parallel. The
Display cable is a standard Cat 5e
ethernet cable.
Electrical continued …