Sparc Enterprise M3000, Installation Manual

Page: 31 / 68

Chapter 3 Installing the Server 3-11
5. Confirm that the POWER LED (green) on the operator panel is lit.
6. Confirm that “ok” is displayed on the domain console.
7. Check the LED for each component.
For the description of LEDs for each component and its function, refer to the SPARC
Enterprise M3000 Server Service Manual .
8. Press the Enter, "#" (default escape character), and "." (period) keys.
This key combination switches you from the domain console to the XSCF console.
9. From the XSCF Shell, execute the
fmdump
command or
showlogs
command, and
confirm that no errors are found.
For details, refer to Section B.3.4, “Using the fmdump Command” on page B-8 and
Section B.3.2, “Using the showlogs Command” on page B-7 .
10. Connect the system control network to a LAN port on the XSCF unit with an
Ethernet cable.
The system control network has one or more administrative consoles used to
monitor the network. This connection will replace the temporary connection made
between the administration console and the serial port on the XSCF unit. For an
outline of the network connection, refer to
FIGURE 4-1
.
Note – The LAN ports on the XSCF unit conform to IEEE 802.3i and IEEE 802.3u.
However, only the auto negotiation mode can be used for negotiation. The fixed
mode cannot be used.
3.5.1 Verifying the Configuration
Verify the hardware configuration by following this procedure on the administration
console connected to the system control network.
1. Log in to the server, and access the XSCF Shell.
For details, refer to the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers
XSCF User’s Guide .
2. From the XSCF Shell, type the
showhardconf
command.
All the components installed in the server and their statuses are displayed. For
details on how to use the
showhardconf
command and an output example, refer to
Section B.3.1, “Using the showhardconf Command” on page B-4 .
3. Confirm that no asterisk (*) is displayed in front of any FRUs.