Sparc Enterprise M3000, Installation Manual

Page: 15 / 68

2-1
C H A P T E R
2
Preparing to Install the Server
This chapter describes the items that you must prepare for installing the server.
■
Section 2.1, “Safety Precautions” on page 2-1
■
Section 2.2, “Before Installing the Server” on page 2-2
■
Section 2.3, “Requirements for Server Installation” on page 2-6
2.1 Safety Precautions
Observe the following precautions during server installation.
Failure to do so may result in damage to the server or a malfunction.
■
Observe the precautions, warnings, and notes on handling shown on the server.
■
Do not block any ventilation holes.
■
Avoid installing the equipment in a place exposed to direct sunlight or near
devices that becomes extremely hot.
■
Do not install the server at a location that has a lot of dust or that is exposed to
corrosive gases or air with a high salt concentration.
■
Do not install the server at a location exposed to frequent vibrations. Install the
server on a flat and level surface.
■
The grounding resistance must not be greater than 10
Ω
. The grounding method
varies by the building where you install the server. Make sure that the facility
administrator or a qualified electrician verifies the grounding method for the
building and performs the grounding work.
■
Do not place cables under the equipment. Do not have cables stretched tight. Do
not disconnect a power cord from the server while its power is on.