Spacelabs Healthcare elance 5, Service Manual

Page: 63 / 94

Troubleshooting
System Startup
When the monitor is powered ON, observe the following sequence:
1. The LED on the front panel should illuminate in green after the On/Off button is depressed and the
monitor will beep once.
2. A boot screen will be displayed for a while.
3. Normal screen will be displayed and the monitor will beep twice.
4. NIBP zeroing and EtCO
2
warning up (if EtCO
2
is installed) message will be displayed after the
two beeps.
Power-ON Diagnostics
Power-ON diagnostic tests verify system hardware integrity during power-ON and can often help isolate
and troubleshoot a problem. The normal screen will be displayed after the completion of the Power-On
diagnostics.
Diagnostic Menus
Recorder diagnostic is available for testing the recorder. It can be accessed through <Monitor Setup> /
<Biomedical> / <Service> / <Recorder Diagnostics>. Diagnostic result will be printed from the recorder.
Error Log
For troubleshooting intermittent problems, the monitor maintains an error log for both recoverable and non-
recoverable errors in its battery-backed, non-volatile memory. All diagnostics failures are logged in the
error log. Most errors relate to the Zbitsy Board.
Event log can be access through <Monitor Setup> / <Biomedical> / <Service> / <Show Event Log>.
5-2